Stormworks: Build and Rescue

Stormworks: Build and Rescue

SBS Gryphon Mk.II Rescue Helicopter (LEGACY)
Showing 1-10 of 16 entries
< 1  2 >
Update: 2 Oct, 2019 @ 10:05am

Updated SBS Gryphon Mk.II Rescue Helicopter.

Update: 2 Oct, 2019 @ 9:53am

Updated SBS Gryphon Mk.II Rescue Helicopter.

Update: 2 Oct, 2019 @ 9:25am

Updated SBS Gryphon Mk.II Rescue Helicopter.

Removed Manual Throttle control for Ducted Assist. Ducted Assist is more relevant to speed controls under Hold Speed and AP. Manual control was only useful to assist with rolling with wheels on the ground. With the changes to RPS I implemented rolling across ground is more practically just using pitch controls. Therefore it was removed to simplify controls and clutter.

Small change to Interior (thresholds and stairs).

Navigation Lights changed from RGB Lights to Small Spotlights to lessen the "bleed" of the light back in to the cockpit.

Update: 1 Oct, 2019 @ 10:37am

Updated SBS Gryphon Mk.II Rescue Helicopter.

Tweaked PID settings and Pitch Hold settings for Ducted Assist to allow for better transitions from Pitch Forward speed to Ducted Fan Assist speed. Makes Hold Speed changes a bit more responsive.

Update: 30 Sep, 2019 @ 9:17pm

Updated SBS Gryphon Mk.II Rescue Helicopter.

Small modification to cockpit configuration.

Update: 30 Sep, 2019 @ 1:37pm

Updated SBS Gryphon Mk.II Rescue Helicopter.

Altered some gearing and RPS settings in order to improve fuel efficiency and stability. Helicopter now has flight Idle of 45 rps to start (was 75 rps previously). Help with Fuel burn and also with turning at high speed (flopping over and wobbling has been greatly reduced).

Changed rail setup in back of Helicopter so that they are "reversed": grippers are in floor. This allows for the grippers to take electricity directly from the helicopter and any palette/structure does not require onboard electricity. Control for the rails are now near the rear of the cargo bay. The Port buttons control the brakes and detach controls for the two rows of grippers on the Port side broken up in to zones A-F. The SB buttons control the brakes and detach controls for the two rows of grippers on the SB side broken up in to zones A-F. The change allowed for the readdition of Triage beds in the back that actually "stuck".

Added 6 Mag-Alls in back that can be controlled from one panel.

Changed the Lift Bar/Box to a simple one Mag-All with 2 winch setup. The previous version was "ugly" and not very practical.

Removed the water and fuel connection interior to the cargo bay as they were not very effective. It required separate pumps to be on any palettes that were in the bay.

Update: 23 Jul, 2019 @ 11:22am

Updated SBS Gryphon Mk.II Rescue Helicopter.

Update: 3 Jul, 2019 @ 11:22pm

Updated SBS Gryphon Mk.II Rescue Helicopter.

Quick fix relative to Gearbox changes.

Update: 24 Jun, 2019 @ 7:11pm

Updated SBS Gryphon Mk.II Rescue Helicopter.

Fixed Issued with gearing and power transfer to small generators that were inline just after the Main Rotor. Due to the recent Electric Fix (0.7.11) the generators caused more drag on the drive shaft. I upped the RPS on the gears prior to the main shaft, removed the supplemental gears that were connected to the generators and ensure the RPS Monitor was just prior to the entry to the Main Rotor. Fixed the issue and helicopter is back to Flight Idle of 60 RPS. Also seems to have improved Fuel Consumption.

Add sengir_vampire's Compass Band to the HUD.

Update: 7 Jun, 2019 @ 9:40pm

Updated SBS Gryphon Mk.II Rescue Helicopter.