Stormworks: Build and Rescue

Stormworks: Build and Rescue

评价数不足
ZE Smart Railroad Signals Controller
   
奖励
收藏
已收藏
取消收藏
标签: v1.10.9
文件大小
发表于
更新日期
164.266 KB
2023 年 10 月 3 日 上午 7:23
2024 年 4 月 16 日 下午 8:56
5 项改动说明 ( 查看 )

订阅以下载
ZE Smart Railroad Signals Controller

描述
Place the physics sensor in the middle between the track rails and keep its orientation.

A controller subassembly for the smart railroad signals addon that should be installed on the train locomotive.
  • Indicates the state of the one signal ahead and of the one signal behind the train on the track it currently occupy, and can switch that signals individually. Works correctly if there are several signals near the train, and if the correct signal is not the closest one to the train.
  • Maximum distance of operation is 150 - 50 meters, depending on track curvature. Switches the signal only after receiving its state, but you can pre-hold the switch button before entering into the signal area if your train is moving too fast.
  • Uses radio frequency 4401 to transmit its position and orientation, and frequencies 4402 and 4403 to receive the signals state.
  • Place the physics sensor in the middle between the track rails and keep its orientation. You can split the other parts and place them anywhere you like.
  • Works for the signals in both directions simultaneously. Install both instrument panels correspondingly if your locomotive has two cabs, or only one panel for the corresponding single cab.
  • If you are using two separate controllers in the rolling stock locomotives that are connected back-to-back, it will be active only in one direction of the signal that is closest to any locomotive.
  • Replace the constant on part with the button to disable the constant radio broadcast on frequency 4401.
1 条留言
Uran_Wind  [作者] 2023 年 10 月 4 日 上午 7:18 
If signals controller doesn't work, make sure you have updated the addon to the latest version.