Butiksside
Stormworks: Build and Rescue
Alt Diskussioner Skærmbilleder Illustrationer Broadcasts Videoer Værksted Nyheder Guider Anmeldelser

Stormworks: Build and Rescue

Butiksside
Stormworks: Build and Rescue >  Værksted > Uran_Winds værksted
Ikke nok vurderinger
ZE Smart Railroad Signals Controller
Beskrivelse Diskussioner0 Kommentarer1 Ændringsbemærkninger
   
Pris
Føj til foretrukne
Gjort til foretrukken
Fjern som foretrukken
Vehicles: Vehicle, Land, Subassembly, Advanced
Tags: v1.10.9
Filstørrelse:
Offentliggjort:
Opdateret:
164.266 KB
3. okt. 2023 kl. 7:23
16. apr. 2024 kl. 20:56
5 ændringsbemærkninger ( vis )
Påkrævede emner
Dette emne kræver alle af de følgende andre emner
Designet af:
Uran_Wind
Offline
Se alle 97 samlinger (nogle kan være skjulte)
2,382 Unikke besøgende
1,162 Nuværende abonnenter
38 Nuværende foretrukne

Abonner for at downloade
ZE Smart Railroad Signals Controller

Beskrivelse
Place the physics sensor in the middle between the track rails and keep its orientation.

A controller subassembly for the smart railroad signals addon that should be installed on the train locomotive.
  • Indicates the state of the one signal ahead and of the one signal behind the train on the track it currently occupy, and can switch that signals individually. Works correctly if there are several signals near the train, and if the correct signal is not the closest one to the train.
  • Maximum distance of operation is 150 - 50 meters, depending on track curvature. Switches the signal only after receiving its state, but you can pre-hold the switch button before entering into the signal area if your train is moving too fast.
  • Uses radio frequency 4401 to transmit its position and orientation, and frequencies 4402 and 4403 to receive the signals state.
  • Place the physics sensor in the middle between the track rails and keep its orientation. You can split the other parts and place them anywhere you like.
  • Works for the signals in both directions simultaneously. Install both instrument panels correspondingly if your locomotive has two cabs, or only one panel for the corresponding single cab.
  • If you are using two separate controllers in the rolling stock locomotives that are connected back-to-back, it will be active only in one direction of the signal that is closest to any locomotive.
  • Replace the constant on part with the button to disable the constant radio broadcast on frequency 4401.
1 kommentarer
< >
Uran_Wind  [ophavsmand] 4. okt. 2023 kl. 7:18 
If signals controller doesn't work, make sure you have updated the addon to the latest version.