Fixed an issue where the pegs would not load correctly.

Through more troubleshooting, I realized and I found out that the peg model that I was using from a Steam Workshop resource was a .txt file that was importing the file from another website. When I investigated that website, it seems that the website no longer exists, or is blocked for certain countries. So, I had to go hunting in my Steam data files to hopefully find a locally saved .txt or .obj file for the peg that I could upload to the Steam cloud myself. Luckily, I found it.

Thank you for your patience if you had problems with the pegs not loading.

- The pegs are now a .obj file loaded from the Steam cloud.

Thanks to RalK, Maya, Blairiam, junii.km, and Wolf for pointing out this issue.

Fixed an issue where the popper would spawn in another dice, and interfere with gameplay.

In my testing, it seemed, on rare occasion, when the dice lands on certain spots, the popper wouldn't detect a dice inside, so it would spawn in another dice. I believe this occurred because I made the dice too small in v1.02.

- Made the dice super slightly larger (from .80 to .85 units)
- Increased the dynamic friction to help the dice land more smoothly (from .7 to .9 units)

Thanks to Indranyx for pointing out this issue.

Made changes to help prevent the dice from getting stuck on the sides and to help the dice roll/bounce better, all to prevent lame dice rolls that land on the same number.

- Made the dice popper slightly larger
- Made the dice slightly smaller and bouncier

Thanks to mysticbluekitten for pointing out this issue.

- Fixed an issue with the error message "Failed to create Token from Image" where the remnants of a developer test token attempted and failed to load because the texture was removed from the cloud save data

Thanks to Crichton for pointing this out.

The original upload date.