Suscríbete para descargar
[LK]Temperature Reactor_Controller by Luka

This controller is theoretically of the best ones after 0.19 version:
It adjust its output by adjust its temperature instead of turbine,which gives it the ability to adjust its output rate at the speed of 20%/s,which is 10 times as fast as the cases with no controller at all and 4 times as those traditional controllers who use turbine to adjust output,and could not be quicker after 0.19.
Besides,it also perform better than normal temp-control reactors as it would not slow down when the temperature approached the aimed value,at the cost of little oscillation after adjustment.
And,it have all virtues a good old controller before 0.19 once had:no power decline in cases with single U rod,no overheat when initialize,no overheat when load far exceeds reactor's maxpower,and no need for calculation and adjustment every time you upgraded your reactor.

There may be a little room for improvement,which however would require disproportionate components and efforts.
After deploying this mod,you can find this component in the "Item Assembly" blank.Then just link up lining as following texts.
Link up lines as picture 2.

And edit the divide component in the upper left:

clamp max=5000/basic maxoutput
clamp min=4170/basic maxoutput
Both values are only accurate to 0.1,so make the maximum bigger and make the minimum smaller.For example,if you calculated and got 1.343/1.12 as your result,then fill in 1.4/1.1 .


Thanks to Yun-Shan's work.