Store Page
Stormworks: Build and Rescue
All Discussions Screenshots Artwork Broadcasts Videos Workshop News Guides Reviews

Stormworks: Build and Rescue

Store Page
Stormworks: Build and Rescue >  Workshop > Grimper's Workshop > Ulysses Expedition Submarine > Discussions
Ulysses Expedition Submarine
Description Discussions5 Comments359 Change Notes
 This topic has been pinned, so it's probably important
Grimper  [developer] 22 Jun, 2023 @ 6:19am
Ramp issues
The cargo ramp is a bit...temperamental. Stormworks does not like it when grippers are so close to the ground and sliding through a narrow opening.

If the ramp gets stuck, try some of these solutions:

- Turn pivot power on and off
- Turn mags on and off
- Disconnect and reconnect the power cable (it attaches in the very middle block of the ramp)
- Close the door on the ramp, then open it again
< >
Showing 1-5 of 5 comments
lechkingofdead 24 Jun, 2023 @ 11:11pm 
is the ramp supost to remign in the up state when its slide out?
Last edited by lechkingofdead; 24 Jun, 2023 @ 11:14pm
#1
Grimper  [developer] 25 Jun, 2023 @ 12:09am 
Originally posted by lechkingofdead:
is the ramp supost to remign in the up state when its slide out?
Yes, it makes it easier to handle in narrow docks where you don't have the room to fully extend.
#2
lechkingofdead 25 Jun, 2023 @ 5:30pm 
Originally posted by Grimper:
Originally posted by lechkingofdead:
is the ramp supost to remign in the up state when its slide out?
Yes, it makes it easier to handle in narrow docks where you don't have the room to fully extend.
ya i was just being a little derpy did not notice how the ramp exists :P i learned AFTER i feel into a gap of one after i got it to lock right. so i learned how it works
Last edited by lechkingofdead; 25 Jun, 2023 @ 5:31pm
#3
DoneSonBoi 3 Jul, 2023 @ 10:28am 
I can't make the ramp go out.
its gets stuck at the electric connecters, and doesn't close or open after that.
I'm just trying to send the helicopter out, so I don't crash into the shallow waters.
How do I disable these electric connecters can someone please tell me.
#4
Grimper  [developer] 4 Jul, 2023 @ 12:23am 
Originally posted by DoneSonBoi:
I can't make the ramp go out.
its gets stuck at the electric connecters, and doesn't close or open after that.
I'm just trying to send the helicopter out, so I don't crash into the shallow waters.
How do I disable these electric connecters can someone please tell me.

The ramp follows a complex sequence, in a very specific order, to deploy and undeploy. Very occasionally something can happen to mess up this order (like damage to the microcontroller, or a large wave/tsunami) and the ramp gets confused.
At this point usually the only way to fix it and get it back in the correct order is to respawn the vehicle. Even if I included a way to disable the connectors, the ramp still wouldn't work properly.
Last edited by Grimper; 4 Jul, 2023 @ 12:24am
#5
< >
Showing 1-5 of 5 comments
Per page: 1530 50