i cant even find this?!!?!??

i cant get it working?

If anyone has got this working can you please tell me where im going wrong?

if you use this with the speed limiter you made and shut off the gps before you reach the destination you cant manually choose speed but if you put an [and gate] after the sr latch and connect it to the sr latch and the gps on off toggle then the output to composite write on off it then fixes this problem

Yes

Can I use this in a vehicle that I am making?

Can I tweak some stuff to make this auto stop in stations? Or is there a premade micro controller that stops in the exact station like your new train project.

Ok thanks

Add another 0 and see if that works, I will look to add a slider to the MC for it to be more friendly to configure and makes adjustments :)

You would need to add more damping in the PID settings.

when the train comes near the stop it slows it self down but if you have a heavy train, the inertia will keep the train roling and when the train passes the stop point it thinks it have to go to the point so it starts accelerate in the wrong direction.

But could you explain what I have to tweak? Cause its not an issue in pid, at least i dont think si....Cause its not an issue of how much away from target it stops..it never stops. The desired speed is staying as the fistance from waypoint, so after I pass waypoint speed goes back up again amd train never actually stops. So what is there to tweak??

You might have to tweak it to work with your train, But as shown in the video works.

bro it doesnt work...after four hours of trouble shooting in your video I just realised that you have done something wrong...Even this mc has same problem i was experiencing when I followed your tutorial...it passes destination, desired speed goes to 0, but then climbs back up o.o PLS fix this

Good work im using it in my "sj x2000 snabtåg" train

Does, Follow Tutorial Video

doesnt work :|

thx

great!