Subscribe to download
[SDX] Tug550 Print / Projector Tug

An ultra-low-PCU print tug designed for the Sigma Draconis 'The Expanse' ('SDX') server, and look decent.

Small enough to be hand welded.
Designed to be Merged to your Station static grid printer when not in use - be sure to set one grid to Station prior to doing merges.

To use, build a sprue off the tug to your aligned projection. Pull your print. Enable the docking connectors on your print and dock to your station. Cut off sprue.

Toolbar pre-setup:
* Page 1 - general functions
* Page 2 - Projector -/+ offset
* Page 3 - Projector rotation


Designed with Multi-Grid Projection plugin in mind mod (Toolbar button for 'Highlight Blocks'), but otherwise not required.


Other notes/guidelines:
* Remember to !fixship your printed grid prior to enabling any blocks (like the docking connectors on your print).
* SDX prints start powered off, but be sure to NOT enable any weapons that that can drain the tug battery, as there is no built-in power-generation.
* Be sure to up/down power the gyro as needed.
* successfully tugged up to 10Mkg grids - just use a little patience.


BLOCKS: 35
PCU: 552
DRY MASS: 50897 KG
H2 STORAGE: 1ML
CARGO STORAGE: 27000 L
ACCEL: RCS
POWER: 12MW MAX - Single Battery
WEAPONS MOUNTS: [NO WEAPONS]

DLC: Heavy Industry, Decorative Blocks, Decorative Block 2 (2x optional front 'catwalk' parts)

SDX Creative world:
https://gtm.steamproxy.vip/sharedfiles/filedetails/?id=3113386643

Information on SDX server:
https://wiki.sigmadraconis.games/