Subscribe to download
Artillery Cannon Loader "Belt Butler" MK1A

This vehicle is apart of my Battlemetal Confederacy Tank Series I'm working on, check my workshop for more Battlemetal Confederacy Tank Series tanks. https://gtm.steamproxy.vip/id/The-Tank-Guy/myworkshopfiles/

This vehicle is meant to be used as an loader for tanks in my MK1 Series to load artillery cannon belts, so if you use this on other vehicles I can not tell you that this will 100% work for it.

This vehicle is made to be used on the Dreadnought MK1 tank, which is the same tank in the pictures, and it can be found here: https://gtm.steamproxy.vip/sharedfiles/filedetails/?id=3198187616

Needed Crew: 1 or 2.

To get on top of this vehicle you can use the stair case on the left side of it.
And on the right side of it there is a hatch, which can be used in different ways like, you can use it to get to some equipment, or to fix the engine, or to use as cover in a battle, that is why you can lock the hatch, and the same reason why I put guns in there.

Engine Facts: The WarFront Motors V8 Engine runs at 900 RPM, it uses 1x1 cylinders, and it uses one air and fuel manifold.

It also only uses roughly 0.8 liters per second, and it has a fuel tank of roughly 1100 liters, and the engine temp only goes up by roughly 0.15 per second, sense it only gets one radiator.

Loaders Seat: Once you get into the seat you can see all of the controls to position the ammo belts to line up, and once you are lined up with the belt the light on the back of the long piece of ammo that you connect with other ammo belts, lights up then that means you are connected, then you should hold LMB to transfer ammo to the other belt.

If you find any bugs or you have any suggestions you think could make the tank better, please let me know about them in the comments.