Store Page
Barotrauma
All Discussions Screenshots Artwork Broadcasts Videos Workshop News Guides Reviews

Barotrauma

Store Page
Barotrauma >  Workshop > IT9's Workshop
Not enough ratings
Easier Flood Resist Duct Block
Description Discussions0 Comments4 Change Notes
   
Award
Favorite
Favorited
Unfavorite
Item Assembly
File Size
Posted
Updated
51.073 KB
20 Jul, 2021 @ 5:44am
4 May, 2022 @ 4:49am
4 Change Notes ( view )
Created by
IT9
Offline
See all 25 collections (some may be hidden)
651 Unique Visitors
181 Current Subscribers
28 Current Favorites

Subscribe to download
Easier Flood Resist Duct Block

Description
This duct block slows flooding from above and stops flooding from below.

Steps to install the duct block:

  1. Open your submarine with the submarine editor.
  2. Find out the hull volume by selecting the hull (one at a time).
  3. Set the value of the memory components respectively.
  4. Choose a wait time. Longer wait time will work better on preventing flood but poorer on water draining. If you have no idea, just use the default value 1.5.
  5. Set the value of delay component equals to the wait time.

The duct block behaviours the same as Flood Resist Duct Block, but easier to configure.

This mod is not intended for studying the wiring. If you want to understand the logic behind the duct block, it will be a lot clearer to look at Flood Resist Duct Block.
4 Comments
< >
Tajima Akuna 10 May, 2022 @ 7:30am 
thank you Sir yea i found it out a little bit later when i looked up the optimal floating numbers ^^ for the nav terminal
IT9  [author] 10 May, 2022 @ 4:38am 
Regarding step 2, find out the hull volume by the following steps:

1. Open a submarine in the Submarine Editor.
2. On the menu at the top, select Toggle visibility > Hulls.
3. Those blue rectangles are the hulls, select one of them.

A box should be shown on the top, the Selected hull volume is the value we are finding.
Tajima Akuna 5 May, 2022 @ 3:57pm 
if you talk about step 2 the hull volume you talk about max healt?
IT9  [author] 21 Jul, 2021 @ 5:24am 
The instruction to configure the wait time was wrong.

The correct value to be set in the delay component should be equal to the wait time. That is, 3 seconds delay will make the duct block to open and check the change of water level every 3 seconds.

I have updated the mod’s description.

Sorry for the confusion.