Subscribe to download
Amtrak Capitol Corridor

This is a train based on the Amtrak Capitol Corridor train, run by the California Department of Transportation in and around the Bay Area.

The train consists of a GE P32-8BWH "Dash-8" Locomotive and two bilevel California Cars, the second of which is a cab car to allow the train to quickly switch directions without having to turn the entire train around. And in case you are wondering, yes, the cab car is fully functional.

Controls (both the locomotive and cab car have identical sets of controls):
1: Start/stop engine
2: Toggle Forward/Reverse
3: Train horn
4: Train bell
5/6: Increase/Decrease throttle
7/8: Open left/right side passenger doors (the left and right is relative to the direction the train operator is facing)

The throttle has 7 positions, with 0 being no power, and 6 being maximum power

Each of the passenger doors can also be opened independently of the master door open switch through a button, which will open the door for three seconds before closing it.

The train is designed to run on LordPain's 7-wide rail assets, but it will run on any track with 7 blocks between the rails (whether it can do so reliably has not been tested)

WARNING: This is a large creation with quite a few moving parts. Do not be surprised if you get <20FPS with this train (my usual was 15FPS standing still and 12FPS on the move)



Do not reupload without explicit permission from me
Note: This is a revised version of my previous Capitol Corridor train with shorter connections between the cars and locomotive