Store Page
Space Engineers
All Discussions Screenshots Artwork Broadcasts Videos Workshop News Guides Reviews

Space Engineers

Store Page
Space Engineers >  Workshop > tyrsis's Workshop > Nanite Control Factory - Automated Construction (Not working - Old Version) > Discussions
Nanite Control Factory - Automated Construction (Not working - Old Version)
Description Discussions242 Comments3377 Change Notes
Dkz1181 8 May, 2016 @ 10:19am
Screwy half block orintation
The link to the world is below, tho you'll have to friend request to gain access as im not wanting to make this public, the nano's seem to work fine with my other projections laying out as normal but for some reason on this particular section its rotated the halfs by 90' from the projection :S

http://gtm.steamproxy.vip/sharedfiles/filedetails/?id=655581978
< >
Showing 1-3 of 3 comments
Dkz1181 8 May, 2016 @ 10:20am 
hell, u can even see the screw up in the screen shot, that was conviniant lmao
#1
tyrsis  [developer] 8 May, 2016 @ 6:32pm 
It's pretty difficult for me to know which blueprint caused that. Can you setup your save with your projection going (with nanites off, before they start building it) so I can see them building the thing all crooked? If I can isolate the issue before it happens, then I can properly debug it. You just have a lot of stuff, and it's hard for me to know what is what.

Just set it up and republish for me, and I should be able to see it happening.
Last edited by tyrsis; 8 May, 2016 @ 6:33pm
#2
Dkz1181 9 May, 2016 @ 9:11am 
ahh right, sorry, i thought i had, one sec.. its the only projector running and thts BC WING LEFT 2 or wing left 2 cant mind which now im out.. but just head to the GPS marker nanite ♥♥♥♥♥♥!!!! the projector hologram is running and nanites are started to build, u can grind off the complete half that are out of synic and watch as they are put back out synic ... yet its working fine for my other blue prints just seems to be this one, tho ive yet to try the 22 degree plane blue print i have stored as well
Last edited by Dkz1181; 9 May, 2016 @ 9:26am
#3
< >
Showing 1-3 of 3 comments
Per page: 1530 50