Página de la tienda
Space Engineers
Todo Discusiones Capturas Artwork Retransmisiones Vídeos Workshop Noticias Guías Reseñas

Space Engineers

Página de la tienda
Space Engineers >  Workshop > Workshop de CiberX15 > VCZ Multifloor Elevator 1.199 Fix > Discusiones
VCZ Multifloor Elevator 1.199 Fix
Descripción Discusiones5 Comentarios196 Notas sobre cambios
MagnusEffect 10 SEP 2022 a las 2:45
User Manual
Didn't see this posted anywhere so is a copy of the original guide:

Main Elevator blocks:
VCZ Elevator Rotor Base - Main ELevator block that goes at the bottom of your elevator. Use VCZ Elevator Middle or VCZ Elevator Middle Double for your first floor instead of VCZ Elevator Bottom. First floor can have Fillers or Filler Vent between it and the Base.
VCZ Elevator Rotor - Main Elevator block that goes right above VCZ Elevator Bottom. This is the old way to build an elevator and is useful if you don't have space under the first floor.

Floor blocks:
VCZ Elevator Bottom - The block for the first floor if you are not using VCZ Elevator Rotor Base;
VCZ Elevator Middle - The block used for any other floor between the first and the last;
VCZ Elevator Middle Double - Same as VCZ Elevator Middle but 2 blocks tall for a floor level with half blocks;
VCZ Elevator Top - The block for the last floor;

Filler blocks:
VCZ Elevator Filler - A filler block to place between floors.
VCZ Elevator Filler Double - A 2 blocks high filler block to place between floors.
VCZ Elevator Filler Vent - Same as above but also works as an Air Vent.
< >
Mostrando 1-1 de 1 comentarios
MagnusEffect 17 ABR 2023 a las 16:49 
PRO-TIP: I'm not entirely certain of the purpose of the "VCZ Elevator Rotor Base" when you can skip it in favor of using the "VCZ Elevator Bottom". That's what I did to get it working after Automotons update.

ALSO: The "VCZ Elevator Rotor" is the actual "elevator car" and MUST go immediately ABOVE the "VCZ Elevator Bottom". Failure to do so will cause the elevator not to work correctly.

I recommend starting at the bottom of your elevator and place blocks in this order:

1) Basement/Ground Floor = VCZ Elevator Bottom
2) Between Basement/Ground Floor and 1st Floor = VCZ Elevator Rotor
3) Place Fillers as needed between each additional floor.
4) Place a "VCZ Elevator Middle" for each additional floor except top floor.
5) Place "VCZ Elevator Top" on your top floor.
Última edición por MagnusEffect; 17 ABR 2023 a las 16:53
#1
< >
Mostrando 1-1 de 1 comentarios
Por página: 1530 50