Abonner for at downloade
ULTRAHUB - Wave Roof (Bus)

still can't place bus stop after following all the instructions and tutorials. Maybe it's just I'm dumb...

Hey guys.. I was determined to get this working and I did. Took me about an hour and a half to do unfortunately (I had a major thunderstorm AND earthquake during this span of time and had to tend to the rest of my city, which is why it took so long). You are going to need lots of patience.

Using "Touch It/this" and "Move It" mods, i was able to remove the road that comes with this bus module and add a new bus road in its place. I was able to add bus stops (you have to get really close and almost down to ground level view in order of the stop to catch, but it worked.

I did this in game and not in the editor as I cannot get my editor to work right. I would export my updated bus module for you all, but I don't know how. Oh, i used the open air bus module.
https://gtm.steamproxy.vip/sharedfiles/filedetails/?id=1959531152
https://gtm.steamproxy.vip/sharedfiles/filedetails/?id=1959531183

I've tried everything in the guide and the comments I've seen, and I still can't connect a bus route to the modules. I know I've connected the roads to the right nodes and done it all in the right order, it just won't let me connect a bus route... Any suggestions on fixing the problem?

folder number ? it's the steam workshop link:

927598681

I did exactly like the tutorial. But i can't line up buslines. Tram, Metro and Trains working perfect. Also the open roof module for the busses cannot be used. What am i doing wrong?

Yes, that's what I'm doing. It is ON when building the complex. That's when the tunnel entrances get created INSIDE the complex. This is BEFORE I turn it off and connect any roads, before I add any bus stops.

I turn it OFF before adding any bus stops, but by then it's too late. There's already tunnel entrances inside the bus complex.

It has to be OFF, that's the trick. You need to be ON for building the complex, not after, otherwise game confuses middle segment for snap. Disable it to snap roads. I also recommend to drag tunnel to the station, don't start building the tunnel from the station.

Perhaps I missed something, but that doesn't help.

Road Anarchy is turned ON when I place the bus station, but it still shows TUNNEL entrances inside the bus station (module). This is before I try to connect any roads.

I think that is why I can't put any bus stops, as it thinks those are tunnel entrances, and you can't place a bus stop within a tunnel or at an entrance.

Do you have any other ideas why the bus station / module gets created with tunnel entrances within the station?

Check the guide: http://gtm.steamproxy.vip/workshop/filedetails/discussion/927592155/1290690926864729365/

I can not place BUS "New Lines" within this (or the open roof version) bus station. Neither can I drag in existing bus stops.

Trains and Metro work without issue, but when I place this BUS station (with Anarchy), I also get tunnels within the station

http://imgur.com/a/hW3c6

This is without any DLC packs, just the latest updates in the vanilla game.