订阅以下载
Meier Rescue Service M1B Light SAR Helicopter

-750+ Km range.
-Over 220 Kph top speed.
-Costs $19,000.
-Altitude hold and way-point autopilot.
-Almost all specialist equipment
-18 seats including copilot and pilot seats.
-Only uses around 2000(l) of diesel.
-Auto position hold.
-Auto altitude hold.
-Vehicle parachute
-Well working floats
-Spawnable in starter dock

Spawn in the creation (can be on any physics levels). press 1 on the pilots seat. Use the up/down arrow keys to control rotor collective, left/right arrow keys to control yaw, a/d keys to control roll, and w/s to control pitch. to enable the pusherprop for a boost in speed press 4. To turn off the engines press 1, but if you want to stop the rotors exit the pilot seat, fold the rotors for a few seconds, and then unfold them and they should have stop spinning.

Spawn in the creation (can be on any physics levels). Fold the main rotors, then pull the electric connecter until all rotors clear the dock. Unfold the rotors and press 1 on the pilots seat. Use the up/down arrow keys to control rotor collective, left/right arrow keys to control yaw, a/d keys to control roll, and w/s to control pitch. to enable the pusherprop for a boost in speed press 4. To turn off the engines press 1, but if you want to stop the rotors exit the pilot seat, fold the rotors for a few seconds, and then unfold them and they should have stop spinning.


ECU: ZE Modular Engine Controller
Flight Controller: ZE Coaxial Flight Controller
Fuel Display: CURC (Consumption, uptime and range calculator)
Clutch Controller: Auto Clutch

If you find any bugs or want to suggestion something for this helicopter please tell me in the comments .
If you don't want me using any micro-controller that I have used please tell me in the comments.