Đăng ký để tải xuống
Advanced Furnace Display

​Used with my Advanced Furnace Control to easily select and show the Ingots you want to make.
https://gtm.steamproxy.vip/sharedfiles/filedetails/?id=2714184998

Items Needed:
1x Kit (Consoles)
1x Hash Display
1x Glass Sheet
1x Data Disk to configure console
1x Kit (IC Housing)
1x Integrated Circuit (IC10)

Setup:
1. Place the Console and insert the Hash Display, then install the glass.
2. Place the IC Housing and insert the IC10 chip loaded with this program.
3. Label the IC Housing with labeler as Display IC (or something similar)
3. Wire the IC Housing and Console into the same circuit that the DIAL from the furnace is on.
4. Insert the Data Disk into the console and turn it on. Select the Display IC from the list, then remove the Data Disk.
5. Turn on the IC Housing.
6. Using your screwdriver, set the D0 pin to the DIAL used by the furnace control.