ติดตั้ง Steam
เข้าสู่ระบบ
|
ภาษา
简体中文 (จีนตัวย่อ)
繁體中文 (จีนตัวเต็ม)
日本語 (ญี่ปุ่น)
한국어 (เกาหลี)
български (บัลแกเรีย)
Čeština (เช็ก)
Dansk (เดนมาร์ก)
Deutsch (เยอรมัน)
English (อังกฤษ)
Español - España (สเปน)
Español - Latinoamérica (สเปน - ลาตินอเมริกา)
Ελληνικά (กรีก)
Français (ฝรั่งเศส)
Italiano (อิตาลี)
Bahasa Indonesia (อินโดนีเซีย)
Magyar (ฮังการี)
Nederlands (ดัตช์)
Norsk (นอร์เวย์)
Polski (โปแลนด์)
Português (โปรตุเกส - โปรตุเกส)
Português - Brasil (โปรตุเกส - บราซิล)
Română (โรมาเนีย)
Русский (รัสเซีย)
Suomi (ฟินแลนด์)
Svenska (สวีเดน)
Türkçe (ตุรกี)
Tiếng Việt (เวียดนาม)
Українська (ยูเครน)
รายงานปัญหาเกี่ยวกับการแปลภาษา
Thanks
- the towns with no ind/com only grew to match their new basic size and not target pop
- in one of them I was able to create a com zone, by setting it at 500 and waiting 8 years (!); the town had 2 (!) shops and its pop still did not grew past the basic size
- the towns with ind/com grew as they should as soon as the new caps were set at anything above 50, but then they did so at a much slower rate than the organically planted city
- I could completely remove ind zone in one of them, but not recreate it
- the sliders for zone sizes worked for the organic town just fine
The towns I tested were indeed very small, 30-40 residential with 0-20 industrial and commercial capacity. The other, the one plopped by the vanilla tool, had caps of 135.
I placed them in the map editor, not after the game started; I know it makes a difference for some assets.
I did not test your tool on bigger towns yet, but I'm about to.
I ran a test game with 4 very small towns, I supplied them with everything they needed over 5 years and even though they showed that their target population should increase by 140%, they stayed the same size.
I had two somewhat realted mods that could potentially interfere, namely Town Tuning and Urbanization, but after uninstalling them the issue persists.