Installer Steam
log på
|
sprog
简体中文 (forenklet kinesisk)
繁體中文 (traditionelt kinesisk)
日本語 (japansk)
한국어 (koreansk)
ไทย (thai)
Български (bulgarsk)
Čeština (tjekkisk)
Deutsch (tysk)
English (engelsk)
Español – España (spansk – Spanien)
Español – Latinoamérica (spansk – Latinamerika)
Ελληνικά (græsk)
Français (fransk)
Italiano (italiensk)
Bahasa indonesia (indonesisk)
Magyar (ungarsk)
Nederlands (hollandsk)
Norsk
Polski (polsk)
Português (portugisisk – Portugal)
Português – Brasil (portugisisk – Brasilien)
Română (rumænsk)
Русский (russisk)
Suomi (finsk)
Svenska (svensk)
Türkçe (tyrkisk)
Tiếng Việt (Vietnamesisk)
Українська (ukrainsk)
Rapporter et oversættelsesproblem
Thanks
- the towns with no ind/com only grew to match their new basic size and not target pop
- in one of them I was able to create a com zone, by setting it at 500 and waiting 8 years (!); the town had 2 (!) shops and its pop still did not grew past the basic size
- the towns with ind/com grew as they should as soon as the new caps were set at anything above 50, but then they did so at a much slower rate than the organically planted city
- I could completely remove ind zone in one of them, but not recreate it
- the sliders for zone sizes worked for the organic town just fine
The towns I tested were indeed very small, 30-40 residential with 0-20 industrial and commercial capacity. The other, the one plopped by the vanilla tool, had caps of 135.
I placed them in the map editor, not after the game started; I know it makes a difference for some assets.
I did not test your tool on bigger towns yet, but I'm about to.
I ran a test game with 4 very small towns, I supplied them with everything they needed over 5 years and even though they showed that their target population should increase by 140%, they stayed the same size.
I had two somewhat realted mods that could potentially interfere, namely Town Tuning and Urbanization, but after uninstalling them the issue persists.