Nainstalovat Steam
přihlásit se
|
jazyk
简体中文 (Zjednodušená čínština)
繁體中文 (Tradiční čínština)
日本語 (Japonština)
한국어 (Korejština)
ไทย (Thajština)
български (Bulharština)
Dansk (Dánština)
Deutsch (Němčina)
English (Angličtina)
Español-España (Evropská španělština)
Español-Latinoamérica (Latin. španělština)
Ελληνικά (Řečtina)
Français (Francouzština)
Italiano (Italština)
Bahasa Indonesia (Indonéština)
Magyar (Maďarština)
Nederlands (Nizozemština)
Norsk (Norština)
Polski (Polština)
Português (Evropská portugalština)
Português-Brasil (Brazilská portugalština)
Română (Rumunština)
Русский (Ruština)
Suomi (Finština)
Svenska (Švédština)
Türkçe (Turečtina)
Tiếng Việt (Vietnamština)
Українська (Ukrajinština)
Nahlásit problém s překladem
Thanks
- the towns with no ind/com only grew to match their new basic size and not target pop
- in one of them I was able to create a com zone, by setting it at 500 and waiting 8 years (!); the town had 2 (!) shops and its pop still did not grew past the basic size
- the towns with ind/com grew as they should as soon as the new caps were set at anything above 50, but then they did so at a much slower rate than the organically planted city
- I could completely remove ind zone in one of them, but not recreate it
- the sliders for zone sizes worked for the organic town just fine
The towns I tested were indeed very small, 30-40 residential with 0-20 industrial and commercial capacity. The other, the one plopped by the vanilla tool, had caps of 135.
I placed them in the map editor, not after the game started; I know it makes a difference for some assets.
I did not test your tool on bigger towns yet, but I'm about to.
I ran a test game with 4 very small towns, I supplied them with everything they needed over 5 years and even though they showed that their target population should increase by 140%, they stayed the same size.
I had two somewhat realted mods that could potentially interfere, namely Town Tuning and Urbanization, but after uninstalling them the issue persists.