Инсталирайте Steam
вход
|
език
Опростен китайски (简体中文)
Традиционен китайски (繁體中文)
Японски (日本語)
Корейски (한국어)
Тайландски (ไทย)
Чешки (Čeština)
Датски (Dansk)
Немски (Deutsch)
Английски (English)
Испански — Испания (Español — España)
Испански — Латинска Америка (Español — Latinoamérica)
Гръцки (Ελληνικά)
Френски (Français)
Италиански (Italiano)
Индонезийски (Bahasa Indonesia)
Унгарски (Magyar)
Холандски (Nederlands)
Норвежки (Norsk)
Полски (Polski)
Португалски (Português)
Бразилски португалски (Português — Brasil)
Румънски (Română)
Руски (Русский)
Финландски (Suomi)
Шведски (Svenska)
Турски (Türkçe)
Виетнамски (Tiếng Việt)
Украински (Українська)
Докладване на проблем с превода
Thanks
- the towns with no ind/com only grew to match their new basic size and not target pop
- in one of them I was able to create a com zone, by setting it at 500 and waiting 8 years (!); the town had 2 (!) shops and its pop still did not grew past the basic size
- the towns with ind/com grew as they should as soon as the new caps were set at anything above 50, but then they did so at a much slower rate than the organically planted city
- I could completely remove ind zone in one of them, but not recreate it
- the sliders for zone sizes worked for the organic town just fine
The towns I tested were indeed very small, 30-40 residential with 0-20 industrial and commercial capacity. The other, the one plopped by the vanilla tool, had caps of 135.
I placed them in the map editor, not after the game started; I know it makes a difference for some assets.
I did not test your tool on bigger towns yet, but I'm about to.
I ran a test game with 4 very small towns, I supplied them with everything they needed over 5 years and even though they showed that their target population should increase by 140%, they stayed the same size.
I had two somewhat realted mods that could potentially interfere, namely Town Tuning and Urbanization, but after uninstalling them the issue persists.