Butikssida
Stormworks: Build and Rescue
Alla Diskussioner Skärmbilder Konst Sändningar Filmer Workshop Nyheter Guider Recensioner

Stormworks: Build and Rescue

Butikssida
Stormworks: Build and Rescue >  Workshop > esas workshop
Otillräckligt med betyg
Helicopter altitude hold
Beskrivning Diskussioner0 Kommentarer7 Ändringar
   
Utmärkelse
Favorit
Favoritmarkerad
Avfavoritmarkerad
Vehicles: Air
Microcontrollers: Navigation, Microcontroller
Taggar: v0.9.19
Filstorlek
Lades upp
19.285 KB
20 dec, 2019 @ 3:08
1 ändringsnotis ( visa )
Skapat av
esa
Offline
Se alla 23 samlingar
781 Unika besökare
537 Nuvarande abonnemang
8 Nuvarande favoriter

Abonnera för att ladda ner
Helicopter altitude hold

Beskrivning
Just a simple altitude hold for helicopters.
SIZE:
3x2
Logic connections:
Altitude hold toggle input
Altitude sensor input
Desired altitude input
Collective input
Collective output

You can use this in your creations, but remember to credit me.
And lastly, have fun!
7 kommentarer
< >
esa  [skapare] 8 mar, 2021 @ 23:44 
Okay, thanks for the feedback, I might do that at some point. Right now I really donä't have interest in Stormworks. But thanks for the feedback!:Khappy:
PinkTurkey 8 mar, 2021 @ 17:24 
mine does use two gyros to stabilize, so it could just be that
PinkTurkey 8 mar, 2021 @ 17:22 
very good altitude hold. one thing i would suggest is limiting the collective depending on how fast you are going. my helicopter runs off a propeller and a jet and it overshoots the target a little bit
esa  [skapare] 31 dec, 2020 @ 5:04 
Nice to hear that this helped:)
goonicide 30 dec, 2020 @ 16:32 
THANK YOU IVE BEEN LOOKING FOR ONE OF THESE FOR SO LONG FOR MY CARRER HELI
esa  [skapare] 14 dec, 2020 @ 23:02 
You put the up/down from the seat to the collective input and the collective output to the gyro and from the gyro to the rotor.
oHantuss 14 dec, 2020 @ 21:35 
Where do i put the collective input and output thats all Thanks