- Fix for logged exception from Paste Builder macihe when unable to store excess paste when docking.

- Fix stored paste emptying and storage state update not being performed when Paste Builder is not assigned to a task.
- Paste Builders will now properly release the current task and return to base if attached storage is lost.
- Paste Builders info popup will now show a message if there is no attached storage.

- Fix stored paste emptying and storage state update not being performed when Paste Builder is not assigned to a task.
- Paste Builders will now properly release the current task and return to base if attached storage is lost.
- Paste Builders info popup will now show a message if there is no attached storage.

Fix removal of Truss and Window cubes when set to not remove decor cubes.

Move segment scanning and task assignment to a central process in a seperate thread for a massive scanning speed increase and to remove heavy load off LFU thread.

- Disable task debug messages.

- Improved task delegation between clearing and floor tasks.
- Change site marker assignment to round robin to avoid scenario where Paste Builders get stuck in a loop attempting a task that cannot be performed on the same site repeatedly because paste storage is full or empty.
- Better job switching when paste is empty/full.
- Reduced drone travel for in-range tasks.
- Destruction of paste decor blocks will now yield the penaly amount of one unit of paste as is done with other in-game dig mechanics.

- Add option to ignore ore blocks.
- Fix another case for paste builder stuck outside minimum task distance.
- Fix estimate net paste value counting air as a yield.
- Add paste yield amounts to Paste Builder handbook entry.

Site marker will now allow room tasks to begin earlier if there are more than 250 pending build tasks.

- Paste Builders will not longer remove torches or black/yellow chevrons when replace existing decor is off.
- Paste Builders will not longer perform the inactive wait delay if there are tasks at the site marker.
- Changing the remove existing decor setting to on will force a re-scan without restart the current scan.
- Changing the remove existing decor setting to off will only force scan restart if there are pending tasks.