Strona w sklepie
Cities: Skylines
Wszystko Dyskusje Zrzuty ekranu Prace graficzne Transmisje Wideo Warsztat Aktualności Poradniki Recenzje

Cities: Skylines

Strona w sklepie
Cities: Skylines >  Warsztat > Warsztat użytkownika JSF-1
Zbyt mało ocen
Orion VII (Next Generation)
Opis Dyskusje0 Komentarze5 Lista zmian
   
Przyznaj nagrodę
Ulubione
Ulubione
Usuń z ulubionych
Assets: Vehicle
Rozmiar pliku
Zamieszczono
Zaktualizowano
1.072 MB
20 lutego 2016 o 12:24
24 lutego 2016 o 14:26
Listy zmian: 2 ( zobacz )
Twórca
JSF-1
Offline
Zobacz wszystkie kolekcje (97) stworzone przez JSF-1 oraz innych użytkowników (niektóre mogą być ukryte)
1,433 Unikalni odwiedzający
868 Obecni subskrybenci
23 Obecne ulubione

Zasubskrybuj, aby pobrać
Orion VII (Next Generation)

W 1 kolekcji stworzonej przez JSF-1
Toronto Collection
Przedmioty: 176
Opis
Based off the design used in Toronto by the TTC.

With the huge success of the Orion VII, Orion International created a "next-gen" version of its product. The Orion VII NG featured new seating layout and a sloped front end. As well it came in many forms such as Diesel, Hybrid, and EPA10. The TTC purchased 444 of the Orion VII Next-gens with a mix of Diesel and Hybrids. However the Hybrids were known to break down often and the cost saving promised never materialized. The TTC would convert the Hybrids to Diesel use. The TTC would purchase many more of these including 60 of the EPA10 mod

UPDATE: Added Colour Variation.

Capacity: 60
Top Speed: 100Km/h
Komentarzy: 5
< >
pingucanada 30 września 2019 o 16:40 
Hey I found something,Thomas!!!!!!!
[Delta ²k5] 10 marca 2016 o 12:06 
I spotted two problems:

1. the wheel on the back left does not rotate. Maybe it's set too high above the models origin ;)
2. the model has a strange shadowing - it seems like you have put two parts together (front and back). The model creates a shadow on half of the bus as seen from one side if driving through a streetlight. The reasons for this are the following:

1. if you have put two objects together you probably didn't merge the vertices (select two who are in the same spot and press alt + m in blender).
2. if you did so you have to fix the normals. As the sides are flat select them in faces mode, then go to the Shadings/UVs tab on the left hand where you also got the create tab and select for faces "flat" and for edges "smooth". select then all edges which have to be sharp and set them to sharp the same way.


Also, why are the rims red and not in line color?

Best regards
-SuperLuigi- 20 lutego 2016 o 19:31 
this and first generation! DUDE! I LOVE YOU <3
greenz18 20 lutego 2016 o 19:00 
Way to go!
Captain-No 20 lutego 2016 o 13:33 
fit well in the -Canada- all in one Collection:
http://gtm.steamproxy.vip/sharedfiles/filedetails/?id=508267880
thank you, Thumbs up