Kauppasivu
Stormworks: Build and Rescue
Kaikki Keskustelut Kuvakaappaukset Taideteokset Suoratoistot Videot Workshop Uutiset Oppaat Arvostelut

Stormworks: Build and Rescue

Kauppasivu
Stormworks: Build and Rescue >  Workshop > Käyttäjän The Tank Guy Workshop
Ei tarpeeksi arvosteluja
IronCore Systems Gunners Control System MK3
Kuvaus Keskustelut0 Kommentit4 Muutokset
   
Palkinto
Lisää suosikkeihin
Lisätty suosikkeihin
Poista suosikeista
Vehicles: Vehicle, Technical, Mechanical, Subassembly, Advanced
Tunnisteet: v1.11.6
Tiedostokoko
Julkaistu
Päivitetty
245.760 KB
14.7.2024 klo 18.56
15.7.2024 klo 23.20
3 muutosilmoitusta ( näytä )
Vaadittu lisämateriaali
Tämä luomus vaatii seuraavat lisäsällöt
Stormworks: Search and Destroy
Tekijä
The Tank Guy
pelissä
Tank Mechanic Simulator
dante.rib
Kirjautunut ulos
Näytä kokoelma
59 Uniikkeja kävijöitä
12 Nykyiset tilaajat
1 Nykyiset suosikit
Tarvitset lisäosan käyttääksesi tätä esinettä.

Tilaa ladataksesi
IronCore Systems Gunners Control System MK3

Kuvaus
This is a official IronCore Systems model. This is the IronCore Systems Gunners Control System MK3.

This is a turret aiming system which is controlled by what direction you are looking in, which only will happen after you press "1" on your keybroad while sitting in the gunners seat.

The MK3 uses a cannon type of artillery cannon.

It's reload rate is 6.0 seconds per round, which on stock it has 60 rounds, which you can add as many as you would want to add.

This modal also is installed with a infrared Laser Rangefinder, which is enabled by pressing "4" on your keyboard.

And it gets set range in which you can aim up or down.

dante.rib: They were the one who made the ramp going up to the gunners seat.

If you find any bugs with this modal then please let us know by posting a comment below.

If you want to see later versions of this system, or tanks, then check out my workshop page. https://gtm.steamproxy.vip/id/The-Tank-Guy/myworkshopfiles/
4 kommenttia
< >
The Tank Guy  [tekijä] 19.7.2024 klo 23.10 
So, it could be a negative to add enough blocks to fully support the gun because if I added all of them then all that would do is make it harder to install the MK3 into a already existing tank.
The Tank Guy  [tekijä] 19.7.2024 klo 23.06 
It will work better when you have more things to support the gun then there is in the most basic build. This workshop item so more for installation into a tank or something of the like, rather then just being a bare bones turret control system showcase.
Robs_Reef 19.7.2024 klo 22.39 
And it becomes completely useless when switched to low physics detail.
Robs_Reef 19.7.2024 klo 22.38 
The gun is very floppy for me. It can barely hold itself up.