상점 페이지
Barotrauma
전체 토론 스크린샷 아트워크 방송 동영상 창작마당 뉴스 가이드 평가
Barotrauma >  창작마당 > DuckieMcduck 님의 창작마당
평점이 부족합니다.
Automated search/turret light sweep assembly
설명 토론0 댓글1 업데이트 노트
   
어워드
즐겨찾기
즐겨찾기됨
즐겨찾기 해제
Item Assembly
파일 크기
게시일
업데이트일
24.330 KB
2023년 5월 5일 오후 3시 21분
2023년 5월 8일 오후 7시 01분
업데이트 노트 2개 (보기)
제작자
DuckieMcduck
온라인
모음집 27개 모두 보기 (숨긴 상태 몇 개 있을 수 있습니다)
417 순 방문자 수
91 현재 구독자 수
16 현재 즐겨찾기 수

다운로드 위해 구독하기
Automated search/turret light sweep assembly

설명
This is an example component for making automated sweeping lights in the submarine editor.

Modify your search light angle limits and clamp the multiplication component with your intended angles to make it sweep (default is horizontal; minimum 179 and maximum 359.

If you'd like it to go faster, you'll have to increase both the turret turn speed limit and the frequency of the oscillator.

It comes with a periscope connected to a text display to help you check what angles are ingame, but is unrelated to the circuit and can be removed. A small battery is attached to help debug it without having to power the sub.

댓글 1개
< >
Brashscar 2023년 6월 26일 오후 6시 40분 
might i suggest setting the memory to 720 instead of 360 as using 720 would make it possible to account for the use of negative numbers when you are setting up the turrets
for example i wanted to use this on a turret that was at a 38 degree angle so the angles of the spot light if i wanted it to cover from shell to shell would leave it with angles of -170 to 30
since i changed the memory to use 720 i was able to set the min and max of the component to 190 to 390 and it would actually sweep the entire angle else it would just stop when it was facing straight out the right
i hope i was able to explain that well if not then i hope you were able to get the point im trying to make as i think it would make it easier to use this for things that are not always at a nice 90 or 180 angle