Abonner for å laste ned
XS MODUS - Deep Sea Exploration Submarine

Disclaimer: The airlock will not function and there is no ventilation system, I have not had the time to fix these since the space update came out



So why this submarine? Well firstly it was designed for YOU the end user! I have created other submarines in the past that in my opinion are cooler but nobody could use them. Do you want to wait 15 mins to start a submarine? no? that's why this submarine exists. All of its features are designed to make life easier for the casual explorer and to be practical in most uses. This is the perfect submarine to check out anything added in the underwater update or just general exploration. More advanced users may also load other equipment into the front bay and transport it using this submarine.

• startup time ~ 40 seconds
  
• average speed underwater 120 mph
  
• average speed above water 55 mph
  
• infinite range and depth
  
• comes with all major navigation systems designed by XS logic Co.
  
• airlock functions at any depth
  
• can hover underwater and move in any direction with driver input
  
• comes with the same high-quality safety systems found on the XS pressure seeker along with fire suppression systems

Jet mode is the default mode for traveling anywhere fast in which the water jets are providing the power for movement. Use the following steps if you need help driving in this mode.

1. There is no startup procedure because the engine in this submarine is always on.
   
2. It takes approx 40 seconds for this to happen you can track the progress on the front center console where battery voltages are shown.
   
3. Once the startup process has completed you can use the helm to drive manually using the listed key binds
   
4. to use the depth hold, either use the "hold current depth" button or enter a target depth then hit "go to target" be aware of the belly proximity and and that you must re press the target button if you change the target.
   
5. The submarine comes equipped with two auto pilot systems, The custom autopilot simply takes a coordinate and directs your boat towards it. This system is located in the central console. Additionally the advanced autopilot is also located there.
   
6. To use the advanced autopilot first select the "draw" button then draw a path on the map. ** the zoom keys are to the right of the screen
   
7. After you have drawn the line turn the key for the autopilot to enable the path following.
   
8. you may also choose to enable the "full throttle" button found on the center console.

1. To enable Hover turn the key on the front center console on the right side.
   
2. Be aware the auto pilot and depth hold will not work with this mode, meaning you will need to control all movements from your helm.
   
3. The controls for this mode are mostly the same as before however the "/" marks separate the different binds on the controls menu.
   
4. finally if you wish to land the submarine on the ocean floor simply use alt+down arrow to set the trim down on the hover mode. -.14 is recommended.

1. Open the bay doors.
   
2. Disconnect the Electrical Cable.
   
3. Get in the drivers seat of the ROV.
   
4. Carefully drive out of the bay.

1. either back up or drive up to the bay while it is open.
   
2. using the ropes in the bay connect the rope anchors on the ROV to the winches in the bay.
   
3. make sure the sliders are forward when you connect the ropes .
   
4. pull the winches in until the front or back of the ROV is inside the bay.
   
5. set the sliders to move to the back of the bay. This should pull the ROV inside.
   
6. Connect the Electrical Cable.
   
7. close the bay doors.

Using the airlock is fairly simple but i thought I would include a small blurb.

• If you are outside the airlock and need to go inside press the button to que it up during this time you must stay in range of the player sensor while the airlock empties or fills to open the door.
  
• once the door opens go inside then press the "fill/flood" button
  
• once the fill flood button has been pressed press the exit button for the side you wish to leave on.
  
• the airlock will either empty or fill then the door will open for you
  
• the door will automatically seal after you get out of range of the player sensor