Butiksside
Stormworks: Build and Rescue
Alt Diskussioner Skærmbilleder Illustrationer Broadcasts Videoer Værksted Nyheder Guider Anmeldelser

Stormworks: Build and Rescue

Butiksside
Stormworks: Build and Rescue >  Værksted > Craig Ps værksted
Ikke nok vurderinger
Radar Interpreter
Beskrivelse Diskussioner0 Kommentarer18 Ændringsbemærkninger
   
Pris
Føj til foretrukne
Gjort til foretrukken
Fjern som foretrukken
Microcontrollers: Calculation, Navigation, Microcontroller
Tags: v1.3.15
Filstørrelse:
Offentliggjort:
Opdateret:
32.226 KB
22. nov. 2021 kl. 21:49
6. dec. 2021 kl. 11:32
4 ændringsbemærkninger ( vis )
Designet af:
Craig P
Offline
Se alle 13 samlinger (nogle kan være skjulte)
1,100 Unikke besøgende
415 Nuværende abonnenter
4 Nuværende foretrukne

Abonner for at downloade
Radar Interpreter

Beskrivelse
Couldn't find a simple, accurate, up-to-date radar display, so here it is. Doesn't require any kind of gymnastics - just feed it a signal and it'll put it on a screen.

Works with modern radar! No more weird jitters or obsolete gear.

It's pretty basic, but you can set ranges and when you tap the screen, it'll zoom to the new range smoothly. It's a lot less discombobulating than ones that snap.

You can use this however you like, I don't mind.
18 kommentarer
< >
Redstone_Orange 20. aug. 2022 kl. 0:01 
oh ok, this is the only Radar i found that works with the modern ones. Please make it compatible with the 1x1 screen.
Craig P  [ophavsmand] 19. aug. 2022 kl. 10:28 
1x1 is a bit too small for me, sorry.
Redstone_Orange 19. aug. 2022 kl. 9:08 
Could you make it Compatible with the 1x1 screen?
Craig P  [ophavsmand] 7. juni 2022 kl. 14:20 
That would depend on the orientation of the radar and the screen.
.bishop 7. juni 2022 kl. 13:18 
hi, dont know if its a fault on my side or not, but i think the targets the radar found are upside down, i switched the minus signs (dx and dy) for the targets and the sweeper in onDraw around and then targets are shown were they really are for me. Nevertheless thanks for your awesome work.
ova578 4. jan. 2022 kl. 16:05 
ok np
Craig P  [ophavsmand] 4. jan. 2022 kl. 16:04 
Sorry, that's more than I can do in a comment.
ova578 4. jan. 2022 kl. 14:18 
BTW i am really bad at LUA, so not always shure what it is im looking at haha
ova578 4. jan. 2022 kl. 14:17 
basically You made a fancy animation when you change zoom. It looks good but I would like to always have the 3 inner circles positioned in the same place on the screen, recardless of the zoom
Craig P  [ophavsmand] 4. jan. 2022 kl. 13:31 
Yes, but I'm unclear on exactly what you want. The code for that is all near the end of the script.