Butikssida
Space Engineers
Alla Diskussioner Skärmbilder Konst Sändningar Filmer Workshop Nyheter Guider Recensioner

Space Engineers

Butikssida
Space Engineers >  Workshop > Spaceman Spiffs workshop
Otillräckligt med betyg
Bulldog Fabricator
Beskrivning Diskussioner0 Kommentarer0 Ändringar
   
Utmärkelse
Favorit
Favoritmarkerad
Avfavoritmarkerad
Type: Blueprint
Taggar: ship, small_grid
Filstorlek
Lades upp
1.957 MB
1 nov, 2020 @ 16:04
1 ändringsnotis ( visa )
DLC som krävs
Denna artikel kräver all följande DLC
Space Engineers - Decorative Pack #2
Skapat av
Spaceman Spiff
Offline
Se alla 6 samlingar skapade av Spaceman Spiff och andra personer
221 Unika besökare
62 Nuvarande abonnemang
2 Nuvarande favoriter
Du behöver DLC för att kunna använda denna artikel.

Abonnera för att ladda ner
Bulldog Fabricator

I 1 samling av Spaceman Spiff
Utility Vehicles
65 artiklar
Beskrivning
Spiff's Practical Engineered Solutions, a division of the Weyland-Yutani Corporation, presents Bulldog Fabricator off-world welding ship with two large and six medium cargo containers for part storage. Its low profile coupled with 20 gyroscopes allow unparalleled agility when welding in tight places. Wheel bumpers are located at the top, sides, and rear to minimize bump damage. With realistic (i.e., 1-1-1) settings, the cargo capacity of this high-capacity fabricator, including connector and both welders, is nearly 20,000 steel plates which substantially reduces refill cycle times. Bulldog Fabricator utilizes one large reactor for power.

NO MODS, NO DLC, NO ROTORS/PISTONS; SURVIVAL READY AND PROJECTION BUILDABLE!

SHIP STATISTICS
- 450 blocks
- 4,330 PCUs
- 45 tons empty mass

NOTES FOR BUILDING WITH A PROJECTOR
As shown in the last picture, a single block should be added above the projector to ensure adequate clearance when building, and the projector's vertical offset should then be set to -3.