Zasubskrybuj, aby pobrać
ISL - Hiruda-HC 1230 Constructor

A Medium ship for manual grinding and welding, slightly larger than the Tetra Constructor and with some extra features; extra connectors for more docking options, two gatling guns for defense, an O2/H2 Generator and hydrogen engine for emergency recharge and a drill for clearing ground from job sites or quickly harvesting ice for the engine.

The hydrogen variant will work in space or lunar environments, but is not recommended for planetary gravity.

Tools, Scripts & Weapons:
1 Grinder
1 Welder
1 Drill - for clearing ground
2 fixed gatling guns
2 Landing Gear - underside
PAM script - for autodocking and gravity aligning convenience only, not for mining/salvage jobs.
Fancy Status Display Script - for cargo and power management

Power:
1 Large Battery
2 Large Hydrogen tanks
17 Small Hydrogen Tanks
1 Hydrogen Generator
1 Hydrogen Engine

Movement & Control:
1 Cockpit
1 Remote Control
6 Gyroscopes - Power increase/decrease controls are on toolbar 5
33 Small Hydrogen Thrusters

Cargo Space
1 Drill
1 Grinder
1 Welder
2 medium cargo containers
4 connectors - Port, Starboard, Underside and Rear

Miscellaneous:
2 Spotlights
5 Cameras - Front, Underside, Rear, Port, Starboard
Repair Projector

This ship has an empty mass of 46083 kgs, and can move with a full cargo at a maximum tilt of 90 degrees below horizon.

All Programmable blocks are turned off in this blueprint and all toolbars are the same from the cockpit or remote control.

All ships in this set have a rear mounted Merge block and can be printed using a welder wall with one (large grid) piston. However in this design the merge block will have to be ground down if docking via the rear connector, all blocks that require removal are painted bright red.

Toolbar 1
1. Thrusters All On
2. Thrusters All Off
3. Thrusters Braking On
4. Thrusters Braking Off
5. Lights On/Off
6. Connector Switch Lock
7. Camera Po
8. Camera Sb
9. Landing Gear Switch lock

Toolbar 2
1. Battery Discharge
2. Battery Recharge
3. Camera Front
4. Camera Underside
5. Camera Rear
6. Drill Control
7. Grinder Control
8. Welder Control
9. Antenna Broadcast On/off

Toolbar 3
1. PB [PAM] "up"
2. PB [PAM] "down"
3. PB [PAM] "apply"
4. Gatling Gun Control
5. PB [PAM] "Align"
6. PB [PAM] "homepos"
7. Hydrogen Engine On/Off
8. Hydrogen Tanks Stockpile On/Off
9. H2 Generator On/Off

Toolbar 5
3. Decrease Gyro Strength
4. Increase Gyro Strength

Toolbar 6
1.
2.
3.
4.
5. Repair Projector On/Off