Klikněte na „Odebírat“ pro stažení položky
RMS Baltus

**Spawns at Custom Base Oil Rig (Large)**

**Like my other ships, this one does not handle waves well. Keep them below 100% for a better experience and less water passing through the hull**

This is a *fictional* ship based on turn of the century ocean liners. My main influence was White Star's Arabic, along with the Baltic, and Adriatic. She is somewhat smaller then my Olympus build but is just as packed with interiors, and unfortunately just as laggy as her bigger sister. The ship features include-

-Fwd cargo bay
-Mail hold
-Crew mess
-Officers Quarters
-Officers Lounge
-Chart Room
-Wireless Room
-Wheel House
-First Class Dining Saloon
-First Class lounge
-First Class Cafe
-Plunge Bath
-Turkish Bath
-Medical Bay
-Third Class Dining Saloon
-Third Class General Room
-Third Class Smoking Room
-Engine Room
-Boiler Room
-8 Lifeboats and 4 Life Rafts
-Working anchors
-Working Cargo Boom
-Working Auxiliary anchor boom

The sink button is located in the Wireless room which is located under the bridge

To reach the engine room head down to D Deck either through the Fwd Cargo Bay or through the Third Class General Room at the stern. The "Engineering" door is located in the third class hallway amidship. Take the spiral staircase down to the boilers. Hit the "boiler" and "pump" button on each of the three boilers then head aft to the engine room. In the middle of the room is three eng start switches, make sure to hit all three. Then finally open the Steam valves using the levers directly to the left and right of you. Use the two telegraphs in the bridge to control engine speed.

WARNING: The engines have the possibility to overheat and explode. This usually happened if you are in rough seas and the screws are constantly out of the water and over-revving the engine. Be advised its alot easier to blow engines now and lowering your speed in rough weather is recommended.

To launch the lifeboats lower the winch until it is close to the boat and then turn on BOTH mags(the one inside the lifeboat, and the one on the davit itself) after the boat is attached raise it about halfway and then swing the davit outboard and begin lowering. To release the falls use the button inside the lifeboat or the one on the deck. Note the additional lifeboats housed on the aft deck utilize a 'dual-axial' davit system for loading the double stacked boats. After launching the first set the davits can be swung all the way inboard to hook up the second set of boats for launch without the need to reposition the boats or drag any magnets!

The anchors utilize a one key turn operation, turning the key releases the anchor restraint, lowers the anchor, turns on the mag when it hits the sea floor and stops the anchor chain from lowering further. To raise the anchor just turn the key again and everything will be reversed and the anchor will be stowed automatically. There is also manual raise/lower/release buttons if needed. WARNING do not raise both anchors simultaneously as the mags used to stow have a chance to connect to each other and tangle both anchors together.

The ships lights will flicker on and off and eventually fail while it sinks, try sinking it at night for best effect. She will now also break in half while sinking as well.

I couldnt have gotten this done without the help from the amazing Stormworks community and these solid builders who have generously listed their creations for others to use on the workshop-

-Artwork on the ship was created using Tajin's tool here- http://rising.at/Stormworks/paint.php

- RandomThingsPosted's triple expansion steam engine- https://gtm.steamproxy.vip/sharedfiles/filedetails/?id=1873469789

-NerdyCompGirl's amazing anchor system- https://gtm.steamproxy.vip/sharedfiles/filedetails/?id=1624154611

-WH1T3_No1SE's interactive map- https://gtm.steamproxy.vip/sharedfiles/filedetails/?id=1741968004

-christoph4490's lifeboats- https://gtm.steamproxy.vip/sharedfiles/filedetails/?id=1574069655-

-The floor of the dining room is based off of Quilter Anhel's SS Mauwin- https://gtm.steamproxy.vip/sharedfiles/filedetails/?id=1702874963

-ScoodlyPoodly's boilers- https://gtm.steamproxy.vip/sharedfiles/filedetails/?id=1796038087 (also if you enjoy highly detailed interiors I'd suggest giving his ships a look they are some of the best I've seen!)

-And finally the help of Rasyld_Lel and Nhalok from the Steam forums who helped me set up the break feature and even provided a test bed to help me figure it out.

Check out my other ship the Olympus if you enjoyed this one!

****I will be away from home for several months so unfortunately I can not work on this for a while. I have tried to get it in a stable and bug free condition before I left, I apologize if something comes up that breaks it I WILL NOT be able to do anything about it until most likely the spring.****