Butikssida
Stormworks: Build and Rescue
Alla Diskussioner Skärmbilder Konst Sändningar Filmer Workshop Nyheter Guider Recensioner

Stormworks: Build and Rescue

Butikssida
Stormworks: Build and Rescue >  Workshop > Gristles workshop
Otillräckligt med betyg
Throttle\Winch Control
Beskrivning Diskussioner0 Kommentarer5 Ändringar
   
Utmärkelse
Favorit
Favoritmarkerad
Avfavoritmarkerad
Vehicles: Mechanical
Microcontrollers: Calculation, Modular, Microcontroller
Taggar: v0.10.24
Filstorlek
Lades upp
Uppdaterades
21.214 KB
6 apr, 2019 @ 6:06
11 jun, 2020 @ 11:39
5 ändringsnotiser ( visa )
Skapat av
Gristle
Online
Se alla 6 samlingar
608 Unika besökare
250 Nuvarande abonnemang
8 Nuvarande favoriter

Abonnera för att ladda ner
Throttle\Winch Control

Beskrivning
Use a Throttle control to precisely set the cable length your winch will spool out.

Inputs are:

Throttle setting (number)
Cable Length (number)

Outputs are:

Winch Down (Logic)
Winch Up (Logic)

Occasionally the winch will get into a "bounce" condition. To clear this just adjust the throttle\cable length slightly. I suggest using a low sensitivity on the throttle like %20 - %30.
5 kommentarer
< >
Garry (no mic) 4 jan, 2024 @ 1:05 
but it still doesnt work fully
Garry (no mic) 4 jan, 2024 @ 1:05 
i have fixed it mostly, turns out it was a problem with the crane itself
Gristle  [skapare] 2 jan, 2024 @ 8:06 
Can you post your crane to the workshop? I doubt it's this MC, but will take a look.
Garry (no mic) 2 jan, 2024 @ 6:04 
And once it gets to full throttle the boom just immediately goes vertical like i said in the comment below.
Garry (no mic) 2 jan, 2024 @ 5:34 
im using this microcontroller for a crawler crane and connecting the rope nodes to the boom itself, but whenever i put it up over 60% the winch flips out and forces the boom all the way into the vertical position, i dont know if this is a bug or just a problem with my crane but i dont know how to fix it.