Mağaza Sayfası
Stormworks: Build and Rescue
Tümü Tartışmalar Ekran Görüntüleri Çizimler Yayınlar Videolar Atölye Haberler Rehberler İncelemeler

Stormworks: Build and Rescue

Mağaza Sayfası
Stormworks: Build and Rescue >  Atölye > Momox Kullanıcısının Atölyesi
Yeterli oy yok
Doors+ | Realistic Sealable/Waterproof Sliding Door
Açıklama Tartışmalar0 Yorumlar4 Değişiklik Notları
   
Ödül
Favorilere Ekle
Favorilere Eklendi
Favorilerden Çıkar
Vehicles: Vehicle, Technical, Mechanical, Stationary, Subassembly, Advanced
Etiketler: v0.4.32
Dosya Boyutu
Gönderilme
206.933 KB
29 Eki 2018 @ 9:23
1 Değişiklik Notu ( görüntüle )
Oluşturan
Momox
Çevrimdışı
Momox ve diğer kişiler tarafından oluşturulmuş 50 koleksiyona göz atın (bazıları gizli olabilir)
2,059 Tekil Ziyaretçi
942 Mevcut Abone
13 Mevcut Favoriler

İndirmek için abone ol
Doors+ | Realistic Sealable/Waterproof Sliding Door

Momox tarafından 1 koleksiyonda
mTech
25 öğe
Açıklama
Description
Just a fine looking sliding door to use in your vehicles. Probably used best in Helicopters. Needs Electricity. Part of a series of doors.

Features
- Sealable Sliding Door Design
- Doesn't need constant electricity, but should have an input however
- Features Lock electronic aswell as seal function
- Lock in Place Button (A bit buggy)
- Includes 1 medium Battery
- Quite solid, therefore suitable for high velocity transport

Instructions
- Place in your construction (using the selection grid tool)
- Merge it with your construction
- Feed the red relay on the top side with electricity and a on signal in order to keep the battery charged
- You are not required to change anything else
- Have fun.

Information
- Relays can be a bit buggy
- Credits to Zerosen555 for the idea, its from one of his helicopters, I just recreated it and made it a subassembly
4 Yorum
< >
Momox  [yaratıcı] 5 Kas 2018 @ 10:19 
Actually I only added that motion to make it easier to open the door. You are supposed to move it aroung with a handle, like a real door, but I can take that into consideration....
wowogiengen 5 Kas 2018 @ 9:47 
;-) nope.. I thought it would be sufficient to test it without.
But i think, i have a simpler logic solution.
Just use 2 capacitors for the two tracks. Delay the first in unloading and the second in loading and you get the desired motion.

First track moves the door out immediately.
The second track starts when the first has stopped moving.

Backwards, the second track will slide back immediately and the first track waits until motion has finished.

You need to time both motions, but you can get it quite easily
Momox  [yaratıcı] 5 Kas 2018 @ 3:10 
Have you fed it with electricity (the red relay on the top side)?
wowogiengen 4 Kas 2018 @ 10:20 
Are you sure this works as intended? Cant seem to press the button to close the door again