Kauppasivu
Stormworks: Build and Rescue
Kaikki Keskustelut Kuvakaappaukset Taideteokset Suoratoistot Videot Workshop Uutiset Oppaat Arvostelut

Stormworks: Build and Rescue

Kauppasivu
Stormworks: Build and Rescue >  Workshop > Käyttäjän Momox Workshop
Ei tarpeeksi arvosteluja
Doors+ | Realistic Sealable/Waterproof Sliding Door
Kuvaus Keskustelut0 Kommentit4 Muutokset
   
Palkinto
Lisää suosikkeihin
Lisätty suosikkeihin
Poista suosikeista
Vehicles: Vehicle, Technical, Mechanical, Stationary, Subassembly, Advanced
Tunnisteet: v0.4.32
Tiedostokoko
Julkaistu
206.933 KB
29.10.2018 klo 9.23
1 muutos ( näytä )
Tekijä
Momox
Kirjautunut ulos
Näytä kaikki 50 kokoelmaa, tekijöinä Momox ja muut henkilöt
2,059 Uniikkeja kävijöitä
940 Nykyiset tilaajat
13 Nykyiset suosikit

Tilaa ladataksesi
Doors+ | Realistic Sealable/Waterproof Sliding Door

1 kokoelmassa, tekijä Momox
mTech
25 luomusta
Kuvaus
Description
Just a fine looking sliding door to use in your vehicles. Probably used best in Helicopters. Needs Electricity. Part of a series of doors.

Features
- Sealable Sliding Door Design
- Doesn't need constant electricity, but should have an input however
- Features Lock electronic aswell as seal function
- Lock in Place Button (A bit buggy)
- Includes 1 medium Battery
- Quite solid, therefore suitable for high velocity transport

Instructions
- Place in your construction (using the selection grid tool)
- Merge it with your construction
- Feed the red relay on the top side with electricity and a on signal in order to keep the battery charged
- You are not required to change anything else
- Have fun.

Information
- Relays can be a bit buggy
- Credits to Zerosen555 for the idea, its from one of his helicopters, I just recreated it and made it a subassembly
4 kommenttia
< >
Momox  [tekijä] 5.11.2018 klo 10.19 
Actually I only added that motion to make it easier to open the door. You are supposed to move it aroung with a handle, like a real door, but I can take that into consideration....
wowogiengen 5.11.2018 klo 9.47 
;-) nope.. I thought it would be sufficient to test it without.
But i think, i have a simpler logic solution.
Just use 2 capacitors for the two tracks. Delay the first in unloading and the second in loading and you get the desired motion.

First track moves the door out immediately.
The second track starts when the first has stopped moving.

Backwards, the second track will slide back immediately and the first track waits until motion has finished.

You need to time both motions, but you can get it quite easily
Momox  [tekijä] 5.11.2018 klo 3.10 
Have you fed it with electricity (the red relay on the top side)?
wowogiengen 4.11.2018 klo 10.20 
Are you sure this works as intended? Cant seem to press the button to close the door again