Abonnera för att ladda ner
Block Duplicator

i think im too stupid for it... everything is working as intended, phasing block and reappearing but how do i duplicate blocks? i have always the same blocks then before in front of the phasers and i cant put something into the phasers *headscratch*

OK...... IT WORKS AND THANK YOU FOR EVERYTHING .... I DID NOT KNOW THAT THE PARTS ALREADY CAME WIRED!!! THAT WAS A BIG HELP ..... ONE FINAL QUESTION .... IS IT POSSIBLE TO DUPLICATE IRON AND OBSIDIAN BLOCKS?? I TRIED TO PUT THEM IN THE BAR AND THEY CAN NOT BE PLACED THERE..... JUST THOUGHT I WOULD ASK ....
THANKS AGAIN FOR THE HELP ......
LORENZO

THANK YOU MYTH .... I AM GOING TO SUBSCRIBE TO THIS AND BUY THE BLOCK KIT AND KEEP MY FINGER .... THANKS AGAIN FOR THE WIRING PROCEDURES ....... LORENZO

Tip: Always connect from the output to the input. Never the opposite, what happens is a conflict and ends disconnecting what is already connected.

Connecting the machines:

Step 1:
Connect the SWITCH to all in the PHASER.
Connect the SWITCH to the DELAY GATE input.
Connect the DELAY GATE output to the INVERTER input.
Connect the Inverter output to input 2 of the LOGIC GATE.
Connect SWITCH to input 1 of LOGIC GATE.
Connect the LOGIC GATE output on all PHASER.

Step 2:
Set DELAY GATE to 0.5 s
Set up LOGIC GATE for AND

If all goes well when turning on the machine (with the blocks configured in the PHASER you want). The blocks will disappear and then appear.
Collect the blocks with the SWITCH enabled.
Turn off the machine and wait for ~ 2min.

Hello Lorenzo. Before starting the connections, clean all counters of the machines ("K") or place new machines for the machine. This avoids wrong connections.

could you do me a favor and give me the proper wiring sequence for this .... i have tried several .... but with no avail ...... would appreciate it ........ lorenzodelsavio