Butikssida
Empyrion - Galactic Survival
Alla Diskussioner Skärmbilder Konst Sändningar Filmer Workshop Nyheter Guider Recensioner

Empyrion - Galactic Survival

Butikssida
Empyrion - Galactic Survival >  Workshop > Jaguar1965s workshop
Otillräckligt med betyg
Spawnconcgigacoreex1
Beskrivning Diskussioner0 Kommentarer3 Ändringar
   
Utmärkelse
Favorit
Favoritmarkerad
Avfavoritmarkerad
Blueprint: Base
Taggar: Blueprint
Filstorlek
Lades upp
41.086 KB
8 apr, 2018 @ 20:37
1 ändringsnotis ( visa )
Skapat av
Jaguar1965
Online
Se alla 2 samlingar
112 Unika besökare
19 Nuvarande abonnemang
1 Nuvarande favoriter

Abonnera för att ladda ner
Spawnconcgigacoreex1

Beskrivning
This is a concrete spawn point for Gigacore. It is space based, so no need for pillars etc. Do NOT spawn this on a planet, as it will fall to pieces.

When you spawn the ship, stand on the pedestal, line up the rear ramp on the outline on the spawnpoint, it should go green immediately.

Basic materials, just lots of them.

I love JRandalls ships, but they are a pain to spawn, which is why I have done all of these.

Good luck, I hope these do the trick for you.

All of these spawn bases are what I consider, spawn and forget, as in abandon when you have the ship.

Oh, also, if you are going to land on the spawn point again, do not forget to use the O command BEFORE you spawn the Landing pad. Makes things much easier later.
3 kommentarer
< >
bobo8734 4 okt, 2018 @ 19:45 
I will have to remember that one. I'm reasonably new to the game, with under 200 hours on a crappy non-gamer laptop. It works, but barely for this game.
Jaguar1965  [skapare] 4 okt, 2018 @ 16:10 
It levels it out to the playfield, so when you level your craft with O, it will be level with the landing field. I switched mine to X though, so it is near at hand when I am maneuvering my craft or myself,
bobo8734 4 okt, 2018 @ 16:06 
I like your spawnpad ideas. They are great for making sure you have just the right amount of room for the spawn and a permanent landing space as well! One question: what does pressing the "O" command do?