Forklift Training-Basic Operations
Forklift are widely used to improve the efficiency of logistical distribution systems however this convinient transporting machine may be the cause of serious accidents or casualties if used incorrectly. In order to prevent accidents and or casualties basic operation of the counterback forklift is explained in this video.

Before starting any operation with a forklift ensure the forks are in a proper safe position in accordance with the load or type of pallet to be handled.The recommended width between the forks is 1/2 to 3/4 of the width of the pallet when adjusting the position of forks place them symmetricaly to the center of the forklift.Take extra care to protect hands and fingers from becoming caught in the forks.Before getting on inspect the front and rear surroundings by indication and vocalization.Mount the seat from left side holding on to the assist grip with your left hand and the seat back with your right hand place your left foot on the step to get on the forklift.Adjust the rear view mirrors and fasten the saetbelt. Use the left side of the forklift to get on and off.Getting on and off the forklift or adjustment of the seat is permitted only when the forklift is stationary.Never grab the steering wheel or any operation levers jumping on and off is stirctly prohibited.Hold the steering knob with your left hand confirm that the select lever is placed in neutral position confirm that the parking brake is set than insert the key into the key switch and start the engine.Lift the forks 5 to 10 cm from the ground then tilt the mast fully backward depress the brake pedal.Before starting the forklift always inspect the vicinity of the forklift by indication and vocalization when safety has been confirmed depress the brake pedal and shift the select lever into forward release the parking brake and depress the accelerator pedal to move forward
Now to right angle turns.Drive forward to the center of the aisle and approach the corner gradually when the backrest of the forklift reaches the corner start turning the steering wheel.When the middle section of the forklift arrives at the center of the youre entering return the steering wheel quickly to the straight position.In addition beware of the turning radius difference of the outer wheels as it is different from automobiles.Next right angle turns in revers.Drive the forklift backward down the center of the aisle when the front wheels are about one meter from the corner confirm the corner to turn turn the steering wheel quickly when the front wheels pass the corner while checking the center of the counterweight in the center of aisle behind the forklift return the steering wheel quickly to the straight position.When making right angle turns you must observer the following if the load blocks your vision drive backward if necessary ask someone to assist you adhere to the turning ability of the forklift drive slowly.Always be aware of any obstacles, personnel and surroundings when ascending drive with the load positioned uphill when the height of the load is higher than the backrest secure it to prevent collapsing.