상점 페이지
아세토 코르사 Assetto Corsa
전체 토론 스크린샷 아트워크 방송 동영상 뉴스 가이드 평가

아세토 코르사 Assetto Corsa

상점 페이지
통계 보기:
전 세계 도전 과제
󠀡 2024년 12월 27일 오전 5시 14분
Best way to use the hambreak?
When do I use the hambreak during a drift?
이 주제의 작성자가 게시물을 질문의 답변으로 표시했습니다.
여기를 눌러 게시물로 바로 이동하세요.
첫 게시자: ling.speed:
You use it on corner entry when your speed is close to desired drift speed, so you cant use brakes or throttle to start the slide.

During drift you use it to make your drift line wider instantly or when you only need to widen a bit and it expect it to tighten shortly. Without handbrake to widen the line you have to speed up and that takes time*.

Another use is to stall a transition. If you did something a bit too early - like slowing down for a tighter section, turning in, powerslid to a high angle etc. handbrake can delay the effects of those actions till the car is in right position for them. This is important since you can have more confidence "sending it early" or "a little weak" and eliminate "too hot" mistakes that cant be walked back. This is why you see pros use HB all the time.

In tandems handbrake helps keeping high slide angle without accelerating into the car in front, or to widen the line again after you went tight to catch up.

Just remember that while effects of handbrake come faster than from pedals, its still not instant. What makes it useful is killing grip on rear tyres, and since it takes a second for the grip to come back you should not wait with releasing it till you see the full results.

When pulling hanbrake your mind should go "how much grip do i want to loose for the car to go where i want it" and time it in advance of the result.



*- in drifting we say "you turn with throttle" not because car is rotating on power but that where we go depends SOLEY on speed - since we are locked to using all the grip at all times (we cant unwind the steering and turn less). Handbrake is the only tool we have that can change a line without changing speed. Just from that last statement you can write a small book on when to use it.
< >
전체 댓글 10개 중 1~10개 표시 중
DAprojectTurtle 2024년 12월 27일 오전 9시 37분 
When your at 80mph pull it and turn wheel 360° with your hands off the wheel.
#1
Artan 2024년 12월 27일 오전 10시 15분 
It's 'Hand-Brake'.
#2
R3ddy 2024년 12월 27일 오후 1시 03분 
when you feel hungry
#3
Trezoitao38 2024년 12월 27일 오후 3시 02분 
To start the drift you should always use the handbrake. Also, when you powerliding and you dont have enought power to keep the drift you should use the handbrake too.
#4
Domidayv 2024년 12월 28일 오후 12시 05분 
I like ham!!!

As far as a HAND BREAK goes... You want to pull it immediately when you start your turn, not before, which will put you into a skid, which you will immediately release the break and turn into the skid and power over (hit the gas) and regulate it to a controlled speed. How much depends entirely on the car and settings. On a controller it's easy. On a driving rig or real life, not so much. :steamthumbsup:
#5
󠀡 2024년 12월 28일 오후 12시 28분 
Most of the time I don't need it to start the drift but I have been wondering when to use it during a drift. I watch some videos but I don't think I have seen one that explains it well.

I have a cockpit with a fanatec wheel. Been drifting for awhile. I am just starting out with the 1KHP cars but my favorites have been some of the Gravy Garage cars and a 240sx from DWG.
#6
󠀡 2024년 12월 28일 오후 12시 29분 
Artan 님이 먼저 게시:
It's 'Hand-Brake'.
Nah, pretty sure it's hambreak.
#7
R3ddy 2024년 12월 28일 오후 12시 43분 
You don't need to use the handbrake. Only recommended use case is when chasing in a tandem when you need to slow your car down/match lead car angle or when you're trying to extend you drift in a long corner, other than that it's a good practice to not use it at all.
#8
player 2024년 12월 28일 오후 12시 58분 
Look man, there are lots of ways you can do this all right. Hand braking is the easiest so the first thing I want you to do, I want you to rip that e-brake. All right after you rip the e-brake I want you to power over.
#9
글타래 작성자가 이 게시물을 해당 주제의 답변으로 채택했습니다.
ling.speed 2024년 12월 28일 오후 11시 16분 
You use it on corner entry when your speed is close to desired drift speed, so you cant use brakes or throttle to start the slide.

During drift you use it to make your drift line wider instantly or when you only need to widen a bit and it expect it to tighten shortly. Without handbrake to widen the line you have to speed up and that takes time*.

Another use is to stall a transition. If you did something a bit too early - like slowing down for a tighter section, turning in, powerslid to a high angle etc. handbrake can delay the effects of those actions till the car is in right position for them. This is important since you can have more confidence "sending it early" or "a little weak" and eliminate "too hot" mistakes that cant be walked back. This is why you see pros use HB all the time.

In tandems handbrake helps keeping high slide angle without accelerating into the car in front, or to widen the line again after you went tight to catch up.

Just remember that while effects of handbrake come faster than from pedals, its still not instant. What makes it useful is killing grip on rear tyres, and since it takes a second for the grip to come back you should not wait with releasing it till you see the full results.

When pulling hanbrake your mind should go "how much grip do i want to loose for the car to go where i want it" and time it in advance of the result.



*- in drifting we say "you turn with throttle" not because car is rotating on power but that where we go depends SOLEY on speed - since we are locked to using all the grip at all times (we cant unwind the steering and turn less). Handbrake is the only tool we have that can change a line without changing speed. Just from that last statement you can write a small book on when to use it.
ling.speed 님이 마지막으로 수정; 2024년 12월 28일 오후 11시 36분
#10
< >
전체 댓글 10개 중 1~10개 표시 중
페이지당 표시 개수: 1530 50

아세토 코르사 Assetto Corsa > 일반 토론 > 제목 정보
게시된 날짜: 2024년 12월 27일 오전 5시 14분
게시글: 10

토론 규칙 및 가이드라인